Geared Light Switch Snap On 3D Printer Model
The file 'Geared Light Switch Snap On 3D Printer Model' is (stl) file type, size is 11.9MB.
The file 'Geared Light Switch Snap On 3D Printer Model' is (stl) file type, size is 11.9MB.
I made this so that I can give this as a present to nieces and nephews. The other light switch plates take a long time to print out >14 hours. This light switch plate takes about 4.5 hours with a 0.2mm layer and 55% fill density.
Three of these should fit side to side on a 3 light switch plate. (Comment if you try it out please!)
2 should fit side to side on a two light switch plate.
| 1Switch-SD_-_LSP_R6.stl | 3.0MB | |
| SD_SnapGears_-_Pinion.stl | 14.3MB | |
| SD_SnapGears_-_small_R6.stl | 12.3MB |
