This is my first multi-component project. A gravity phone holder with a mounting-plate. Fusion files are included to remix to whatever you want!
Printed in PETG to withstand hot temperature in my car.
You can attach something like a rubber-band (one the vertical-slider and a bar close to the gear) to open automatically, when you lift up your phone.
It opens from 70-110mm - and can hold phones with about 10mm of depth.
You have to clean your prints (specifically the edges) cause the tolerances are quite low.
Once cleaned it slides super well.
The 2 shells are secured by 3x M3 x 5-6mm screws.
| backplate.stl | 151.5KB | |
| baseplate.stl | 224.6KB | |
| gear_small.stl | 427.0KB | |
| mounting_plate.stl | 259.8KB | |
| phoneholder_v1.f3d | 2.8MB | |
| slider_horizontal.stl | 557.3KB | |
| slider_vertical.stl | 136.1KB |
