Made to fit the V2 tactile H-pattern shifter mod by Antonyart at Thingverse https://www.thingiverse.com/Antonyart
Use flush screws for inner ring and this will sit over and hide two screws also.
Can be made to your preferred settings, but I used PLA at 210° at 50mm/s infill speed/movement speed and printer speed (all 50)
No.supports needed but I suggest high resolution... she'll thickness and infill can be whatever but I'd do at least 2 on she'll
Bottom.layer 3 and top layer 4 in case you want to sand flat.
I haven't chamfered the edge, but if you want to then re-upload and credit me for my work, thay would be fine if it will improve mods for the community.
My 3D printed G29 mod list is so far
-Tactile H-pattern mod V2 with top section at 115% z Axis by Antonyart
-New shifter knob with 8 x 8mm Steal Ball bearings inside for weight (csnt remember artist but it was a Mazda 3 knob with top cap)
-4mm spring pre-tensioner inside shifter for tighter gear selection
-Pedal extension mod to raise throttle pedal.
Let me know if you'd like me to email you my complete file list for newbs
| Gear_select_Key_bottom.stl | 395.2KB | |
| Gear_select_Key_Top.stl | 241.5KB |
