GE Upper Rack Axle V2 3D Printer Model
The file 'GE Upper Rack Axle V2 3D Printer Model' is (stl) file type, size is 33.2KB.
The file 'GE Upper Rack Axle V2 3D Printer Model' is (stl) file type, size is 33.2KB.
This is a remix of Fugops44's axle made for the Triton XL dishwasher. I believe it might also be made for other older GE washers as well. Thanks to him for doing the bulk of the work!
After printing, I found the axle did not fit properly, so I rebuilt it, increasing inner and outer diameter. I also improved the bevel and cutout in order to get the wheel on easily. I made it slightly thicker than the original, so it should be a bit more stable and less prone to the angular wear that causes them to fail in the first place.
Support material is needed for the bottom platform. I used manual support painting to only create supports for this part of the model. I used ABS for this axle with 100% infill, make sure you use a filament that can sustain high temperatures. PLA is not suitable for this use case and will fail on you. Hope this helps!
| GE_Upper_Rack_Axle_V2.stl | 115.1KB |
