The file 'Garmin Striker 4 Plus Mount With Transducer Mount To Fishing Kayak And Using A Jump Starter For Power 3D Printer Model' is (stl) file type, size is 473.3KB.
This is project I have been working on for my fishing kayak.
Part one:
Mount the transducer without drilling into my kayak.
I designed a bracket that uses magnets and a lamp/microphone goose neck to give a secure no-drill attachment to my kayak.
Part two:
Mount the head unit in a visible place that is not in my way.
I designed a mount to work with the bracket that came with my Garmin Striker 4 Plus. It is a pedestal that fits into the start port of my rod holder.
Part three:
Power my Striker 4 Plus using a car jump starter.
There was no modeling for this but it completes the project. The big advantage here is size and weight. The head unit, brackets, wire, and battery combined weigh less than 2lbs.
Please check out my video: http://bit.ly/2ZMHTCh
Check out my other fishing Creations!
Garmin Echomap 4" Slide Cover
https://www.thingiverse.com/thing:6401316
Striker 4 Slide Case-
https://www.thingiverse.com/thing:4355677
Planer Board Storage System-
https://www.thingiverse.com/thing:6004432
Dipsy Diver Holder-
https://www.thingiverse.com/thing:5989727
Star Port Mount-
https://www.thingiverse.com/thing:4332777
Kayak Cupholder/ Rod Holder-
https://www.thingiverse.com/thing:4332777
Garmin Striker 4 Plus Mount with Transducer Mount To Fishing Kayak and Using a Jump Starter for Power-
https://www.thingiverse.com/thing:4082316
| Magnet_Holder_for_Fish_Finder_Transducer.stl | 161.5KB | |
| Magnet_Holder_for_Fish_Finder_Transducer_Inside_Part_1.stl | 29.2KB | |
| Magnet_Holder_for_Fish_Finder_Transducer_Inside_Part_2.stl | 29.2KB | |
| Magnet_Holder_for_Fish_Finder_Transducer_Outside_Part_1.stl | 27.0KB | |
| Magnet_Holder_for_Fish_Finder_Transducer_Outside_Part_2.stl | 332.6KB | |
| Magnet_Holder_for_Fish_Finder_Transducer_Outside_Part_3_.stl | 584.3KB | |
| Striker_4_Mount_Star_Port.stl | 161.5KB |
