didn't finish the full design.. hope to get on it one of this days.
electronics:
two 12v led strips.
three 18650 batteries connected in series (12v).
a simple switch.
the cap (bottom part) is connected with two M3 screws (even though I put 4 holes for them). the holes are to small and require to drill and thred them.
the hook is glued on with 2 part epoxy.
the led strips are glued with hot glue.
dimensions:
hight - 290mm (29 cm)
outer diameter - 38mm
tip - if you want the flashlight to stand by itself then make sure to print a stand for the cap.
I will hook it on a wall when not in use so I didn't add that option.
| Base.stl | 228.5KB | |
| Cap.stl | 221.5KB | |
| Hook.stl | 43.7KB |
