The file 'Garage Building H0 Scale For Road Chain System (Magnorail, Faller Car System Alternative) 3D Printer Model' is (stl) file type, size is 3.4MB.
This is the garage building used to cover the drive unit of the Road Chain System found here.
But of course, you can use this as a standalone building in your H0 scale railroad.
Have a look at the introduction movie.
All files can be printed on standard settings, except for the roof, which has a 0.6mm thickness to give that "corrugated sheet" effect. So, you should print this on a better quality setting and set the wall line width to 0.3mm if your slicer gives you trouble.
Depending on your printer's ability to bridge gaps, you don't need support. The building was test printed on a Bambu lab X1 with supports needed for the drain pipes only.
| door.stl | 9.5KB | |
| garage_door.stl | 28.4KB | |
| roofing.stl | 14.9MB | |
| walls.stl | 1.0MB | |
| window.stl | 3.4KB |
