Galaxy S8 Case For TFT Chinese Replacement Display 3D Printer Model
The file 'Galaxy S8 Case For TFT Chinese Replacement Display 3D Printer Model' is (stl) file type, size is 395.3KB.
The file 'Galaxy S8 Case For TFT Chinese Replacement Display 3D Printer Model' is (stl) file type, size is 395.3KB.
IMPORTANT
This case is ONLY for a galaxy s8 with the flat TFT replacement screen from China.
I had to make this case because other ones wouldn't fit this new taller flat display.
I used M2 20mm machine screws to fasten the bottom. Drill the holes out in the small piece 2.2mm in diameter and 1.8mm into the large piece to fit nicely.
This has been scaled up to fit well for more inconsistent filament and to account for a bit of shrinkage. I use recycled HIPS so i get a bit of inconsistency and boogers here and there. I took a round dremel file to clean all the boogers and smooth out the inside corners to fit perfectly.
If the phone is hard to slide in then do not keep pushing, this will crack the thin glass corners. Either scale up or clean up the inside more.
There are at least two versions of these screens and one is about 1mm thicker. Measure your phone with calipers and if it is 10-10.5mm thick use the thicker screen version of the case.
| S8CASEfinalthickerbottom.stl | 197.0KB | |
| S8CASEfinalthickertop.stl | 599.8KB | |
| S8CASEfinalthinbottom.stl | 181.2KB | |
| S8CASEfinalthinscaledtop.stl | 581.6KB |
