This is a remix of TriGorilla/Heated Printer Bed Mosfet Case" by lilmikey. That version did not fit the heat sink properly on the MOSFET board that I had. The one I adapted for is https://www.amazon.com/dp/B07C4PGXFK?ref=ppx_yo2ov_dt_b_fed_asin_title. The opening for the heat sink was offset and not large enough for this board. I also reduced the top height so the heat sink fins would protrude through and also allow better access to the heavy screw terminals. In addition, I cut out the slot vents on the sides to allow for better ventilation and make a simpler print. I printed the top with the upper side against the print bed with no supports. No changes were made to the base. I may add a second version without any side cutouts I have not noticed any heat up so side vents are probably unnecessary.
| My_Mosfet_Case_Bottom.stl | 1.7MB | |
| My_Mosfet_Case_Bottom_v2.stl | 1.7MB | |
| My_Mosfet_Case_TOP.stl | 6.4MB |
