Funnel with a stopper.
I created the complete STL file of the funnel and found that with support it was too difficult to clean the support from the inner drawer so I broke it down into pieces so you can print individually without support and glue together later.
I left the complete funnel in so you can decide for yourself.
I made this so I could load Gel pellets into a Gel blaster.
The slider is deliberately a bit sloppy to compensate for printing inconsistency.
The stopper will not work with liquid but I am sure with some redesign you could make it so.
Feel free to make any changes .
Keep in mind I am not a qualified designer so this is just something that works for me and I hope you as well.
| Extended_Handle.stl | 2.2KB | |
| funnel_17mm_main.stl | 48.3KB | |
| funnel_17mm_throat.stl | 34.9KB | |
| Funnel_Complete.stl | 69.1KB | |
| funnel_complete_17mm_hole.stl | 68.8KB | |
| Funnel_Handle.stl | 2.2KB | |
| Funnel_Main.stl | 47.1KB | |
| Funnel_Plug.stl | 6.3KB | |
| Funnel_Sleeve.stl | 4.8KB | |
| Funnel_Throat.stl | 25.9KB | |
| Funnel_Wedge_handle.stl | 484.0B | |
| Handle_Support.stl | 484.0B | |
| Trigger_Nub.stl | 113.0KB | |
| Trigger_Slider.stl | 86.4KB |
