I needed a better support for my funnels - easier and faster to 3D print than to order from the catalog.
The first version was a bit small, version 2 has a 40mm support opening.
(Version 1 is the only one I have printed, and is shown in the photos).
Print support will be needed for version 2, but v1 can print without.
UPDATE: added Funnel Support_03 file with a cylinder "holder" instead of the polygon - again, untested - but should give a little better support. Slightly adjusted the position of the center pin for locking along thicker stand rods (or less flexible plastics).
| funnel_support_01.blend | 460.7KB | |
| funnel_support_01.stl | 91.8KB | |
| funnel_support_02.blend | 463.8KB | |
| funnel_support_02.stl | 92.6KB | |
| funnel_support_03.stl | 108.6KB |
