--- Updated with a fully printable design that does not need metal screws
-- 1x full-3d-printable-non-threaded-side
-- 1 x full-3d-printable-screw
-- 2x full-3d-printable-threaded-side
-- camera_holder
-- clamp with attached ball
-- clamp screw
I made a webcam mount that can be easily customized. The ball socket joint receives a 10mm sphere and the stem is 20mm long from the center. This mount can be placed various positions, I've even mounted it to my extruder. The arm uses 2x M4 x 30mm screws and M4 nuts.
I've found this model to be very strong if printed in PETG. PLA works but is brittle and cannot be tightened hard.
Printed with 35% infill
Supports only on the camera holder
-- Updated the download to include 1x female joint so you don't need to reprint both if you break one or get a misprint.
-- Updated files for single female joint. remove the 1 of the 2 5mm spacers.
-- Added a clamp with attached ball
-- Added a separate stl for the clamp screw,
-- Add a larger clamp 62mm
| camera_holder.stl | 1.4MB | |
| clamp.stl | 2.3MB | |
| clamp_screw.stl | 913.7KB | |
| clamp_with_attached_ball.stl | 628.1KB | |
| desk_clamp-62mm.stl | 755.6KB | |
| female_joint_2x.stl | 372.0KB | |
| female_joint_v2_single.stl | 175.5KB | |
| full-3d-printable-non-threaded-side.stl | 191.1KB | |
| full-3d-printable-screw.stl | 625.7KB | |
| full-3d-printable-threaded-side.stl | 469.8KB |
