An afternoon-designed and printed tricopter, designed primarily for Dynam KA22-15M motors (though may fit others, or perhaps many more if you're not afraid of using a drill), a 'standard' 20x40mm servo and a 624 bearing for holding the tail motor (you RepRap builders should have a few of these left :-) )
Shown here mostly assembled, with 10x4.7 propellers attached.
| Body.stl | 1.6MB | |
| FrontArm.stl | 906.7KB | |
| TailArm.stl | 1021.1KB | |
| TailAssyBracket.stl | 893.0KB | |
| TailMotorBracket-MkIII-base.stl | 20.3MB | |
| TailMotorBracket-MkIII-top.stl | 7.1MB |
