Full Size 3 Arm Chandelier 3D Printer Model
The file 'Full Size 3 Arm Chandelier 3D Printer Model' is (stl) file type, size is 21.6MB.
The file 'Full Size 3 Arm Chandelier 3D Printer Model' is (stl) file type, size is 21.6MB.
A full sized 3 arm chandelier printed in PETG or PLA.
This was printed on a 300mm x 300mm bed. It is very easy to print but you will require some parts:
3 x e14 light bulb holders
3 x m10 hollow light bulb holder screws approx. 30mm
Screws
Wires
You will need to print all parts in the orientation given. The arms do not need support. Parts to be printed are:
3 x arms no support
1 x celling top with support
1 x shaft no support
1 x junction box with support
1 x hanger no support
3 x rose no support
3 x candle stick no support
3 x hex nuts no support
I have included an exploded view of the model to help in its construction. You will have to push the wires through the arms, I did this by pushing a thin wire and tying it to the main wires. The 3 m10 printed hex nuts go on the inside of where the arms join (junction box) to secure the arms.
You may need to file the holes where the arms push through as tolerance is tight, it depends on your printer settings.
| 1_x_celling_top_support_.stl | 18.7MB | |
| 1_x_hanger_no_support.stl | 53.0KB | |
| 1_x_junction_box_support.stl | 7.9MB | |
| 1_x_shaft_no_support.stl | 8.7MB | |
| 3_x_arm_no_support.stl | 11.5MB | |
| 3_x_candle_stick_no_support.stl | 793.4KB | |
| 3_x_hex_nut_no_support.stl | 814.0KB | |
| 3_x_rose_no_support.stl | 1.3MB |
