This is a full colour Playstation logo. It was inspired by AwesomeA's awesome designs.
I have almost no experience with 3D modeling, I just converted a 2D image of the logo into a 3d model using 3D Builder for Windows 10. Then I chopped it into pieces according to colour and adjusted the height of each section by colour.
To print this in the right colours you must follow these steps.
- Resize the object to your desired size in your preferred slicer.
- Layer height and infill are not too important. Be aware that if you use less than 100% infill you may be able to see the infill pattern when lit from behind. Use a marker or tape to prevent light from shining through.
- Slice the model and then go to the layer preview of your preferred slicer.
- Scroll through the layers one by one and write down the layer height for where each section starts and ends.
- Start with yellow filament, when that section is done switch to teal or green, then blue and finally red.
