This is a remix from 3Dprintit Exoeskeleton Hand. This remix borns due to the reason that I didn´t have the proper screws, nuts and washers for the connections between the links and cubes that makes hand´s movement easy copyable by this exoesqueleton.
Not only that but the aim was to make it 100% 3D printable, that I achieved in some attemps. Therefore, I share with you the three archives that I made:
The screw is connected with the links by passing them throught the links and the rings, and with the hand properly. So, you need to print two screws per finger, like I show you in the images. It has the name "Tornillo_Exo._Links.stl". I reccomend you a 0.1 mm precision.
The nuts go with the screws, so you can print them at the same time with the screws. It has the name "Tornillo_Exo._Links_1.stl". Also, there are two of this per finger.
The cube that is in the middle of each finger is called "Exo._Cubo_conector_1.stl". It has to be printed with supports.
x10 Screws (Tornillo_Exo._Links.stl)
x10 Nuts (Tornillo_Exo._Links_1.stl)
x5 "Exo._Cubo_conector_1.stl"
I hope you will enjoy having your full 3D printed exoesqueleton hand! Please publish a make, comment and follow me on instagram if you liked it!
I do also add all the files needed, from the original Exoesqueleton.
Esta es una versión modificada de 3Dprintit Exoeskeleton Hand, la cual surgió de no tener los tornillos, arandelas y tuercas metalicas necesarias, por lo que hice lo mismo sólo que impreso en 3D.
Necesitas imprimir 10 de los archivos con el nombre de tornillo y 5 de los cubo conectores para completar una mano. Tené en cuenta que los cubos deben imprimirse con soportes, y los tornillos idealmente con una altura de capa o precisión de 0.1mm, para asegurar su funcionamiento.
Si tenés alguna inquietud no dudes en dejar un comentario!
Me ayudarias mucho si me seguís en mi instagram o publicas un make de esto, gracias!
Disfruta de tu mano exoesqueleto 100% impresa en 3D
| Back_Hand_Left_Hand.stl | 4.8MB | |
| Back_Hand_Right_Hand_1.stl | 4.8MB | |
| Exo._Cubo_conector_1.stl | 122.9KB | |
| Finger_Attachment_Claw_Type_1.stl | 4.8MB | |
| Panel_Joint_1.stl | 14.3MB | |
| Ring_Link_Index_Finger_1.stl | 9.5MB | |
| Ring_Link_Middle_Finger_1.stl | 9.5MB | |
| Ring_Link_Pinky_Finger_2.stl | 9.5MB | |
| Ring_Link_Ring_Finger_1.stl | 9.5MB | |
| Ring_Link_Thumb_1.stl | 9.5MB | |
| Shield_Attachment_Type_1_1.stl | 4.9MB | |
| Shield_Attachment_Type_2.stl | 5.1MB | |
| Tornillo_Exo._Links.stl | 56.0KB | |
| Tornillo_Exo._Links_1.stl | 78.4KB | |
| Wrist_Lock_1.stl | 2.4MB | |
| Wrist_Lock_Link_Pin_2.stl | 1.9MB |
