Frosthaven Monster Caddies 3D Printer Model
The file 'Frosthaven Monster Caddies 3D Printer Model' is (stl) file type, size is 517.3KB.
The file 'Frosthaven Monster Caddies 3D Printer Model' is (stl) file type, size is 517.3KB.
The monster management for Frosthaven isn't wonderful and upon searching Thingiverse, I found a great storage idea by mosjef but wanted to make a few tweeks to the system.
Changes to the original
All other monsters either come with 4, 6 or 10 standees, so There is a 4up, 6up and 10up caddy depending on how many standees the monster needs
For the caddies, you will need to print the following for a complete set
1 x Boss Caddy
1 x Imp Caddy
1 x Scouts Caddy
2 x Guards and Priests Caddy
8 x 4up Caddies
24 x 6up Caddies
6 x 10up Caddies
I printed all the caddies on their spines and only used supports "On the build plate only" to support the pull tab.
The one exception was the boss caddy, that needed full supports
I printed half of the caddies on a Creality Ender 3 v2 Neo using eSun PLA+
I then purchased a Bambu x1 Carbon and printed the remainder on that, including the boxes
I did have some issues with warping on the boxes but adding a brim and raising the bed temp seemed to help
I printed the lids upside down with a brim and they printed fine
Links to the fusion 360 designs where you can play with reducing wall sizes etc
Caddies - https://a360.co/3O0vkwJ
Boxes - https://a360.co/474fHNh
| Boss_Caddy.stl | 59.5KB | |
| Caddy_10up.stl | 39.0KB | |
| Caddy_4up.stl | 35.6KB | |
| Caddy_6up.stl | 36.6KB | |
| Guards_and_Priests.stl | 45.2KB | |
| Imps.stl | 63.1KB | |
| Large_Caddy_Box.stl | 869.6KB | |
| Large_Caddy_Box_Lid.stl | 483.2KB | |
| Scouts.stl | 57.2KB | |
| Small_Caddy_Box.stl | 331.3KB | |
| Small_Caddy_Box_Lid.stl | 455.8KB |
