FrostHaven Map Frame 3D Printer Model
The file 'FrostHaven Map Frame 3D Printer Model' is (stl) file type, size is 4.5KB.
The file 'FrostHaven Map Frame 3D Printer Model' is (stl) file type, size is 4.5KB.
Made to use command strips to attach to a wall.
It is recommended to use the medium size strips on the bottom holder and smalls on the sides. The space on the side pieces are wide enough to use a large or medium, but the strip will need to be cut shorter.
The four bottom pieces have tabs built into the sides to line them up but it will not hold them together. I used superglue to stick then together and then ran a soldering iron on the seams facing the wall to insure a good hold.
| FrostHaven_Map_Frame_Left_End.stl | 3.6KB | |
| FrostHaven_Map_Frame_Left_Middle.stl | 4.2KB | |
| FrostHaven_Map_Frame_Right_End.stl | 3.6KB | |
| FrostHaven_Map_Frame_Right_Middle.stl | 4.2KB | |
| FrostHaven_Map_Frame_Side_Peice.stl | 2.2KB |
