Design: Semi-original concept of Froppy's (or Tsuyu's) goggles from My Hero Acadamia. By "semi", I mean that, try as I might, I was not able to find any consistent reference photos of these goggles. It also didn't help that the design of the goggles in the show has subtle changes throughout the series. As such, I took some creative license when I designed this in Fusion 360. Apologies in advance to you hardcore fans of MHA for the inconsistencies you may have noticed in this design.
Printing: Use supports on the strap loops for the most successful print quality.
Assembly: The front half of the goggles are made up of the following parts: two shrouds, two lenses, the center, and the left and right lens housings. All of these parts are designed to be glued together, preferably with a strong two-part epoxy (I used JB Weld). I modeled in strap loops on the inside for an elastic band to be fed through. The rear band and front section may be pulled apart and are held together by the tension of the elastic band. For a more comfortable fit, I would recommend gluing upholstery foam on the inside over the strap loops.
| Froppy_Center.stl | 1.9MB | |
| Froppy_Lens.stl | 817.6KB | |
| Froppy_L_Lens_Housing.stl | 1.2MB | |
| Froppy_Rear_Band.stl | 413.3KB | |
| Froppy_R_Lens_Housing.stl | 1.2MB | |
| Froppy_Shroud.stl | 161.5KB |
