Front shock mounts for the TRX4m. These mounts give much more room for the servo to move around in for better flex, and allow you to mount the shocks at varying rake angles for better flex.
I designed this for my K10 but should be fine on the Ford as well. Not sure if they will fit on the Bronco or Defender chassis. They mount with the existing small screws for the stock shock mounts, and there's a bracing bar that spans the gap, I use 2 spare 1.5mm hex screws to secure it to each mount.
Please note that in your slicer just duplicate and mirror the mount model to make one for the opposite side. Also rotate the model 90 degrees so the completely flat face is the bottom on the print bed, and print the brace standing up
| Shock_Mount_Brace_Final.STL | 14.9KB | |
| TRX4m_Shock_Mount_V6_Final.STL | 108.8KB |
