Frog Thoothbrush Holder 3D Printer Model
The file 'Frog Thoothbrush Holder 3D Printer Model' is (blend,stl) file type, size is 19.1MB.
The file 'Frog Thoothbrush Holder 3D Printer Model' is (blend,stl) file type, size is 19.1MB.
created this from Frog Thermometer by MustangDave. I have included the frog by itself as an stl with thermometer removed as well as my hacked bled file. I am very new to 3d modeling and did the best I could I had an idea in my head but unfortunately it didn't turn out quit the way I wanted. Originally I wanted just a small base to hold the toothbrush and have the top of the toothbrush supported by the frogs arm. Unfortunately due to my hack job of removing the thermometer part (by far the hardest thing I've done) I ended up adding the tube part to hide the mess underneath. Also because of this the tube part ended up going through the frogs foot, again originally I wanted to have the base mount for the toothbrush mount in front of the foot so that the toothbrush was on angle and then rested on the arm. anyway here it is I think it is still quit decent just not what I had initially envisioned :(
I made this to make a set item for my soap dish here http://www.thingiverse.com/thing:1314140 or
http://www.thingiverse.com/thing:1275438
I have not printed this yet however due to sharp angles on the frogs A$$ as well as his arm I would recommend supports
| FRog2.blend | 15.1MB | |
| FRog2.stl | 46.1MB | |
| frog_toothbrush_holder_.stl | 14.2MB |
