Once again back at frogs. :)
"Frog_chess.stl" was printed with 0.2 nozzle at 0.1 layer height this model is better (larger figures, heads and aligment of them is better).
The file ending "04" i tried and printed succesfully with 0.4 nozzle at 0.2 layer height (worser).
Default is 20*20 square under each frog for good fitment on small travel chess boards.
No supports needed
| Frog_chess.stl | 26.9MB | |
| Frog_chess_04.stl | 27.5MB | |
| Frog_chess_04_seperate.rar | 4.6MB | |
| Frog_chess_seperate.rar | 4.6MB |
