Fridge Magnets 3D Printer Model
The file 'Fridge Magnets 3D Printer Model' is (stl) file type, size is 540.2KB.
The file 'Fridge Magnets 3D Printer Model' is (stl) file type, size is 540.2KB.
This is a sequence of fridge magnets with a recess formed in the back to accommodate a small magnet (10mm diameter, 2.6 mm depth - https://www.amazon.com/dp/B07D8QPG2Y)
The design is snug so no glue should be needed. The magnets can be inserted by placing inside the recess, and approximately securing in place, then placing on a surface (magnet side down), and applying pressure. This could be manual pressure, or with the assistance of a small hammer (with a protective flat surface between hammer and print).
All models can be printed recess-side down (using support). Some can be printed standing up (no support, but use of a raft or brim - gummy bear, Tardis, elephant, Totoro), though best results seem to be with models flat.
Updated 12/32/2023: Totoro and Tardis models scaled up slightly, magnet size still the same.
| elephant-magnet.stl | 61.5KB | |
| Gummy_bear_fridge_magnet.stl | 294.9KB | |
| Spirited_away_no_face_magnet.stl | 133.6KB | |
| Tardis_fridge_magnet.stl | 113.9KB | |
| Totoro_fridge_magnet.stl | 995.3KB |
