My fridge was too small for my beers. So I needed a more efficient way to store the beers... With this 'beerhanger' I can hang my beers in my fridge and still use the space beneath and above. The beers hang in quite tight so there is no risk of them falling out. Only tested with dutch beer bottles (300ml). The bottles are hanging on the glass bottleneck. And not on the beer cap. This prevents the bottles from being de-cap-itated on accident.
The beer hanger is mounted using a couple of m3 screws. I used 12mm long m3 screws and I would advise to use a similar length as it is only held by those screws. You can choose how many beers you want to hang and need to print the matching amount of mounting plates.
HangerAxB.stl
A = Depth in beers (25mm, 100mm, 150mm)
B = Horizontal length in beers
I tested the Hanger3x3 but it failed, so I ended up with a 2x3 hanger. It is held by 4 m3 screws and it is super sturdy. I'm not responsible for any loss of beer! I printed this design with a 0.6mm nozzle. I have not tested it with a 0.4 nozzle yet, but it should not make a difference.
1 beer died during the prototyping phase of this design.
| Hanger1x1.stl | 10.8KB | |
| Hanger1x2.stl | 21.8KB | |
| Hanger2x1.stl | 18.7KB | |
| Hanger2x2.stl | 31.8KB | |
| Hanger2x3.stl | 25.0KB | |
| Hanger3x1.stl | 28.6KB | |
| Hanger3x2.stl | 29.9KB | |
| Hanger3x3.stl | 32.9KB | |
| Mounting.stl | 10.5KB |
