Fraction Discs 3D Printer Model
The file 'Fraction Discs 3D Printer Model' is (stl) file type, size is 145.3KB.
The file 'Fraction Discs 3D Printer Model' is (stl) file type, size is 145.3KB.
Remixed the original model by Nina1982.
I noticed some artifacts in the original file, for some it probably wouldn't bother them. My OCD got the better of me, so I cleaned up each piece. I printed the original container and stored the modified discs in that, but that's when I found the next issue.
The original container had ~0.7mm walls, and with my kids I knew it wouldn't last. The lid was also quite a bit bigger then the bottom, so it was just a place on top. After my kids knocked it over a few times and having to clean up the pieces, I made a whole new container from scratch following the same general size and design. I thickened all sides to 2mm and I also made the lid so that it would fit on with a Friction fit. I liked the original idea of the inside of the lid being a tray to put the discs in as they are working with them, so I made sure to keep that feature as well.
| Fraction_Discs_1-1.stl | 36.3KB | |
| Fraction_Discs_1-10.stl | 31.9KB | |
| Fraction_Discs_1-2.stl | 45.9KB | |
| Fraction_Discs_1-3.stl | 50.3KB | |
| Fraction_Discs_1-4.stl | 19.5KB | |
| Fraction_Discs_1-5.stl | 38.8KB | |
| Fraction_Discs_1-6.stl | 56.9KB | |
| Fraction_Discs_1-7.stl | 35.4KB | |
| Fraction_Discs_1-8.stl | 72.8KB | |
| Fraction_Discs_1-9.stl | 37.6KB | |
| Fraction_Discs_Container_Bottom.stl | 56.1KB | |
| Fraction_Discs_Container_Top.stl | 84.3KB |
