Fractal Node 202 2,5 Inch HDD/SSD Fan Mount Drive Bay 3D Printer Model
The file 'Fractal Node 202 2,5 Inch HDD/SSD Fan Mount Drive Bay 3D Printer Model' is (stl) file type, size is 36.9KB.
The file 'Fractal Node 202 2,5 Inch HDD/SSD Fan Mount Drive Bay 3D Printer Model' is (stl) file type, size is 36.9KB.
A 4-drive bay for 2,5 inch drives which can be mounted on a 120mm fan position inside a Fractal Node 202 mini-ITX case on the GPU side of the main bulkhead.
One side is slightly clipped to accommodate an ASUS GTX1060 3gb with a length of 183mm. (Note that i had to remove the fan shroud since it is longer than the GPU PCB.) A 120mm fan still fits underneath the GPU.
Will fit 4 drives up to 10mm thick. SATA connectors should be pointed away from the GPU. Each drive can be afixed to the mount using 4 screws on 1 side of the drive.
If not using a GPU 2 of these will allow you to mount 8 drives in the case, assuming your m-ITX board has that many SATA connectors. ;)
This mount should also be compatible with the original 2-drive bay on the Node 202. (Untested though!)
Print settings don't really matter much. Just print it sideways; no supports needed.
IMPORTANT: Use heat resistant filament. HDD's can get hot and soften/melt the drive tray! ASA or ABS is recommended.
| HDD_Mount.stl | 166.6KB |
