Motor Mount designed for Wind Catcher RC wing but should fit most spec wings. Two part design. Similar to my other motor design, except the motor is removable and replaceable by removing the bolt.

I have released two versions of the MotorMount file:
V1 has slightly tighter tolerances, if you print it and it doesn't push on easily, you can either sand it slightly or print V2 for a slightly better fit. Varies printer to printer.

Requires:
1 x 25mm M3 socket head cap screw
4 x 10/12 mm M3 socket head cap screw (DEPENDING ON WHICH MOUNT YOU INSTALL - READ BELOW)
1 x M3 nut

UPDATE: 7/28/19 - I got some reports that the originally recommend M3x12mm bolts were cutting it way too close to the windings, especially the one near where the wires enter the motor. I'm now recommending M3x10mm. Slightly less threading, but much less probability of shorting the motor.

UPDATE: 7/29/19 - I went ahead and created two versions of the motor mount, a 10MM and 12 MM version. The labeling is for which screws you should be using. As always, doublecheck how far the screws go in and use your better judgment. On both versions, I also sized up the dome on the bottom where the motor shaft protrudes slightly to give a bit more clearance, compared to the original.

Happy flying!