thank you https://www.thingiverse.com/thing:6622923 .
took a lot of inspiration from fpv wing racer
if you want to contact me, please do so through telegram
maiden, basically: https://t.me/fpv_videos/274
more darring moves: https://t.me/fpv_videos/276
1505 4inch: https://t.me/fpv_videos/282
1404 4500 + 3-4 inch + 4s 600mah = ~200gr
wish it was around 150
3.5-4inch prop is recommended
edit - now I recommend 1505 2900kv with 4inch 4s
servos a regular 5g blue ones. need only 2. one for roll, one for pitch
for the tail you need 15cm 5mm square carbon tube.
actually, after minor modifications chassis can hold 4 servos, 2 for the roll, 1 for pitch and 1 for yaw. Or 2 for the roll, 2 for the V-tail
edit - added a thingy for wall mounting
edit - 1505 with 4 inch prop is FIIRE
edit - added new wing, chassis, camera stool and roll link (fcnkwng_v505.stl, CHASSS_ANALOG_1505.stl, camera_stool.stl, link.stl
edit - soo I decided to say goodbye to square tube for the tail. Now plane uses 8mm round carbon tube, same 150mm in length. Added everything new, v6 is the latest now.
new tail
new wing
new chassis
square tube was selected to work around the problem of round ones - the tail can spin on a round one. so to counterract that I drill 2 2mm holes in the tube. 8mm_tube_drill_cut.stl should make it easier
| 8mm_tube_drill_cut.stl | 492.8KB | |
| camera_stool.stl | 96.2KB | |
| CHASSiS_v500.stl | 454.8KB | |
| CHASSS_ANALOG_1505.stl | 862.6KB | |
| CHASSS_v6_ANALOG_1505_8MM.stl | 978.7KB | |
| fcnkwng_aileron_v6.stl | 346.8KB | |
| fcnkwng_v500.stl | 317.1KB | |
| fcnkwng_v505.stl | 326.0KB | |
| fcnkwng_v6.stl | 654.3KB | |
| link.stl | 23.5KB | |
| plane_angle.stl | 55.7KB | |
| TAILU_v500.stl | 640.1KB | |
| tailu_v6.stl | 9.4MB |
