This is rev.1 of my 3D printed drone racing frame. Suitable for 5inch propellers and 3S/4S LiPo has a place for "standard" FPV camera and 36x36mm flight controller and PDB (30.5mm hole spacing).
I suggest printing armz with ABS or PET-G with thick walls (1.6 or 2.0mm) and at least 40% infill. It is heavier, but should not break that easily
RC parts:
Racestar BR2205 2300KV motors
Racestar RS30A Lite ESC
Omnibus F4 flight controller
PDB
RunCam Swift camera
VTX03 video transmitter
R-XSR receiver
| ArmV3_v6.f3d | 586.3KB | |
| Arm_v3.stl | 339.6KB | |
| Bottom_Plate.stl | 1.4MB | |
| camera_standoffs.stl | 1.8MB | |
| Middle_plate.stl | 2.2MB | |
| rear_standoffs.stl | 1.7MB | |
| Top_Plate.stl | 2.9MB |
