FPV Antenna Roll Stabilizator 3D Printer Model
The file 'FPV Antenna Roll Stabilizator 3D Printer Model' is (stl) file type, size is 45.3KB.
The file 'FPV Antenna Roll Stabilizator 3D Printer Model' is (stl) file type, size is 45.3KB.
This is an FPV antenna stabilizer to solve a problem of having very bad radiation pattern when turning with plane. Plane turns take a lot longer and they fly further away than multicopters so this was very noticeable and disturbing.
This is only 1-axis gimbal so it only helps on a roll axis, I designed this with my Mini Talon in mind so it should be good for peaceful cruising.
The design is also very slim to fit my specific need but I think this way it could be also easily embedded into a frame if needed.
Of course this could be used on a pitch axis as well but I doubt that would be as useful.
(Instructions are for INAV only, version 2.0.0 or later, I have not tested this with any other firmware. Doesn't mean it wouldn't work tho.)
| arm_v4.stl | 81.0KB | |
| frame_v3.stl | 69.7KB |
