Fountain Bird Bath 3D Printer Model
The file 'Fountain Bird Bath 3D Printer Model' is (stl,FCStd,FCStd1) file type, size is 1.9MB.
The file 'Fountain Bird Bath 3D Printer Model' is (stl,FCStd,FCStd1) file type, size is 1.9MB.
You can print most of those with resolution 0.2, but I recommend 0.12 for the sink and casing.
Supports are needed for the pool and casing.
I used PLA at 200 degrees, but PET might be even better.
I left FreeCad file for you to edit to your needs.
Make sure you set it properly for it to be water resistant and don't use toxic materials.
The 12V pump I used is a bit too powerful, so I use it at 7.5V and pushed a little bit of sponge into the hose to lower the pressure. You can use 6V pump for this.
I used:
-12V water pump: https://shorturl.at/eoJZ5 (you may want to consider lower power pump)
-DC 5.5x2.1mm socket: https://shorturl.at/eHRV1
-Power switch: https://shorturl.at/pABH7
-8mm hose
-12V DC power supply (in my case regulated 3-12V)
You can add a fuse for safety and seal the electronics part off with aquarium glue.
Post your print and let me know if your bird likes it! :)
| BirdBath-Casing.stl | 69.8KB | |
| BirdBath-Cover.stl | 684.0B | |
| BirdBath-Pool.stl | 1.7MB | |
| BirdBath-Tank.stl | 66.1KB | |
| BirdBath-Tap.stl | 1.1MB | |
| BirdBath.FCStd | 466.6KB | |
| BirdBath.FCStd1 | 466.6KB |
