Fortnite – Port A Fort 3D Printable Replica 3D Printer Model
The file 'Fortnite – Port A Fort 3D Printable Replica 3D Printer Model' is (stl,STL) file type, size is 2.1MB.
The file 'Fortnite – Port A Fort 3D Printable Replica 3D Printer Model' is (stl,STL) file type, size is 2.1MB.
This is a replica 3D model of the port a fort found in the game Fortnite Battle Royal, this was made on the eve of its announcement when first being released into the game.
When your pinned down on all sides, low on building materials, you need a fort to survive the barrage of bullets and spamming grenades. You need a Port a Fort.
The size of this model is based on rough guesstimations from ingame still shots and promotional posters. All parts have an approx 0.5mm tolerance for fitting and should be printable on any printer without any issues in pla or abs or any other material of your choosing.
You will need to print multiple copies of some parts, those being the following,
Screw (12 of these are needed)
dome (6 of these are needed)
Shell With Detail (4 of these are needed)
Shell Without Detail (4 of these are needed)
it would be best to print the domes in a transparent material or if possible print them, mould them and then cast them in a clear resin for best visibility of the design underneath.
The body can be hollowed if you wish to install lights and electronics.
| body.stl | 713.8KB | |
| dome.stl | 229.3KB | |
| screw.STL | 2.2MB | |
| shell_without_detail.stl | 3.7MB | |
| shell_with_detail.stl | 5.7MB |
