DISCLAIMER:
this is an addition to the very nice and versatile
"Warhammer 40K Defence Wall" [ https://www.thingiverse.com/thing:2194730 ]
and "Imperial Bunker - Small" [ https://www.thingiverse.com/thing:2573739 ]
by SnowMan77 [https://www.thingiverse.com/SnowMan77/about ]
this model has the permission of SnowMan77
Hey,
as said above, this fortification makes the most sense when used in combination with the Defense Wall. It can also be squished in between two small bunkers to form a kind of bastion (it is designed to fit snug). Or you can use it as a fortified position in the ongoing wall. In this case you can connect the wall segments with the connector pieces. The holes in the sides are for magnets, but can be ignored as well (obviously).
The pictured parts where printed quite fast with 0.3 mm layer heigth, soooo they came out as what you can see here. With more patience and a maximum layer heigth of 0.2 mm it should turn out pretty good.
| Fortification.stl | 231.5KB | |
| Fortification_Connector_left.stl | 29.0KB | |
| Fortification_Connector_right.stl | 29.0KB |
