Affix these to the upper grille of your Ford Focus ST and Fiesta ST (may work for other car models too) using permanent double-sided foam tape. I used a roll of the Gorilla brand "indoor/outdoor permanent" foam tape and they stuck very well to the honeycomb pattern in the grille. Should work fine on facelift and pre-facelift model years.
TWO FILES INCLUDED, one for the main fangs and smaller teeth, and another angled tooth for the sides of the grille. Mix and match these in various sizes (resize using your slicer) to get your desired outcome. For reference, I believe the large fangs in the photo are about 10 in long. Print using PLA with a brim and throw in a few extra roof layers otherwise you'll see the infill pattern through the top, especially if using white or light colored filament.
| Fang_type_a.stl | 15.4KB | |
| Fang_type_b_for_sides.stl | 14.3KB |
