FolgerTech FT-5 Dual Extrusion Modifications using two E3D v6 and Titans.
This was just a test file to see how it would fit and only has been printer to test size and how much reduction in print size it would be on the FolgerTech FT-5.
V 2 now places the stepper motors under the railing.
Updated pictures to the new mount. Finally finished wiring the FT-5 and can test out the design. Lost about 60mm of travel on the x-axis. Wiring is a mess and needs to have some improvements. Need a bigger cable chain to fit extra wires.
Firmware changes will have to be done by the user.
Might be better to go with bowden design.
| folgertech_ft-5_backplate_short.stl | 41.7KB | |
| folgertech_ft5__front_plate_dual_e3d_titan_mount.stl | 88.2KB | |
| FT5_Dual_E3D_Titan_Back_V2.stl | 88.0KB | |
| FT5_Dual_E3D_Titan_Front_V2.stl | 88.4KB |
