I loved the simplicity of Mikloshed's 'Ultimate phone stand', however. I noticed the hinge was a pin hinge and the remix by ZUBENIN_INDUSTRIES tried to make this better with a conical hinge. Both these hinges require the centre section of the hinge to print in thin air. So I've made a different type of hinge that NEVER needs to print in thin air and shouldn't stick together at all. (unless your printer is horribly over-extruding.
Oh Yeah, I also added 2 cylindrical voids within the prints to allow you to pop in 2 neo-magnets 8mm dia x 3mm thickness. You'll have to pause the print at the correct layer or pop them in at or just before before 6.8mm height. It doesn't matter if you have no magnets, it should still print fine without
| Folding_PhoneHolder_Better_Hinge.stl | 151.7KB |
![Minimalistic Phone Stand [STL, STEP] 3D Printer Model](https://res.3axis.co/5869bc6d-0fec-46c7-82fe-e232cc63815b/images/a4c1f530-865f-477c-90e1-e01709461f5f_thumb.jpg)
