The file 'Folding FPV Drone Legs / Landing Gear 3D Printer Model' is (stl) file type, size is 204.6KB.
This is a remix of the design below
Fimi A3 drone foldable legs by traffix75 on Thingiverse: https://www.thingiverse.com/thing:4613017
These are folding legs for an FPV drone. The frame I have fit them for is a GEPRC MARK4 but I am sure they will work with many other frames.
I used PETG for testing and fitment, your mileage may vary on your printer settings and material. Fitment is tight, any you more than likely will need to file the hinge holes. I figured it was safest to be on the tighter side (can file off material) than to be too loose. I used needle files.
-Leg Mount: May need to file hinge holes a little
-Leg: For my material and printer, I needed to file the hinge holes to get the pins to fit.
See pictures as well
- Pins
Orientation: Vertical
Supports: None needed
- Leg Mount
Orientation: Vertical
Supports: I print with supports, I put support blockers on the pin holes, so only the bottom and zip tie holes are supported
- Leg
Orientation: Horizontal
Supports: needed to support hinge area
Hinge_Pin.stl | 257.7KB | |
Leg.stl | 126.5KB | |
Leg_Mount.stl | 148.8KB |