Foldable Phone Stand 3D Printer Model
The file 'Foldable Phone Stand 3D Printer Model' is (stl) file type, size is 79.8KB.
The file 'Foldable Phone Stand 3D Printer Model' is (stl) file type, size is 79.8KB.
This is a phone stand adapted from Mike-vom-Mars. His was listed as a phone/tablet stand but my iPhone 6 is not wide enough to be supported by both the low extrusions. I thought about scaling it down but then the top of my phone wouldn't have adequate support. So a few hours of reverse engineering in Fusion 360 and here is my version. I made it so that minimal printed support is needed; however, I did print with supports because of the overhang on the Stand.
| Phone_Stand_BackBar_rev2.stl | 136.7KB | |
| Phone_Stand_Base_Plate_rev1.stl | 101.6KB | |
| Phone_Stand_rev1.stl | 42.5KB |
