Mount (helmet bracket) for Fodsports M1-S Pro / M1-S Plus / M1-S AIR motorcycle intercom (interphone) headset to replace broken original one or to put to different helmets (ski, moto road, moto enduro etc.).
Go over the back surface with a sandpaper and degreaser before gluing. Also heat the foam tape for higher adhesion. It is better to always use safety thread to not miss the intercom in case of falls, branches hittings and so on.
I would recommend to print "Mount for tie" versions as universal one so you could use tie/ thread/cabel temporary in the road if it gets unglued.
Bend the latch down and up manually by finger gently to minimize the possibility of breakage.
You could use "Mount hex and rails" version and connect it (using m2 bolt or glue) with second printed custom part if you need special curve instead of flat surface.
| M1-S_3.4_Mount.STL | 652.1KB | |
| M1-S_3.4_Mount_for_M2.STL | 668.7KB | |
| M1-S_3.4_Mount_for_tie_3mm.STL | 952.5KB | |
| M1-S_3.4_Mount_for_tie_4mm.STL | 952.5KB |
