PLS READ CAREFULLY!!
With a 0.4 nozzle pls set your line width to 0.6mm
PLS SET YOU LAYER HEIGHT TO 0.25
2 perimeter walls = 1.2MM WALL TOTAL
3 bottom layers
3 top layers
100% infill - THE PARTS ARE DESIGNED TO BE HOLLOW OR SOLID
TAIL (MOTOR MOUNT) = 20% INFILL
PS ENSURE THE TAIL SECTION IS FLAT ON THE BUILD PLATE BEFORE PRINTING - CHECK IT IN THE SLICER!
80mm/s for everything
pls take note of the print orientation images
RED HOOD clip gets glued to the TOP section
Lower HOOD clip to the lower section UNDERNEATH - check photo they then slide together with 2 rear pins before flying
Put to holes and two pins (like original Bell/UH1/Airwolf fuse) in appropriate places and line them up carefully for a good rear fit (like original)
When gluing parts together, use some scrap 1mm sheet of material (print a square 'TABS' part included) to cut some strips on the joins and glue the strips in first on ONE PART then align the parts (use them as tabs)
print in PETG
| BRACE.stl | 16.5KB | |
| FIN.stl | 1.1KB | |
| FRONT_LG.stl | 27.6KB | |
| front_tail.stl | 1.0MB | |
| LOWER_CLIP.stl | 27.8KB | |
| MOTOR_PLATE.stl | 57.2KB | |
| mounting_posts_x_6.stl | 684.0B | |
| NEW_HOOD.stl | 878.6KB | |
| NEW_LOWER.stl | 1.0MB | |
| rear_clip_x_2.stl | 1.1KB | |
| rear_fuse.stl | 2.3MB | |
| REAR_LG.stl | 92.8KB | |
| rear_tail_1.stl | 1.2MB | |
| SKID_X_2.stl | 7.5KB | |
| stab.stl | 1.4KB | |
| tabs.stl | 684.0B | |
| TAIL_NEW_HOLES.stl | 2.0MB | |
| TOP_BRACE.stl | 38.2KB | |
| TOP_CLIP.stl | 1.4KB |
