Fluke TL175 test leads holder / reel
Normally I wind up the test leads on the multimeter itself, but when you take out the multimeter from the toolbox to grab something else it would go loose and it is hard to reel up nicely.
This is what I came up with, put the testleads with point at 30 degrees in top of the holder and push down the test lead, than you can reel it up on the holder.
Printed in ABS, PLA or PETG should be fine too, supports are needed for underside of the holder.
| FLUKE_TL175_Holder.STL | 2.3MB |
