Resized Fluffy The Unicorn (about 180mm), removed the recesses for the pupils (I think, it looks nicer once it's painted) and made it hollow using MeshMixer.
Fixed some problematic areas in the inner surface caused by hollowing it out.
Inserted the screw thread at the bottom and created the slot for the coins.
(there is a version with the slot at the front and another with the slot at the rear)
The Unicorn takes about 18h to print at 50mm/sec and 0.2 layer hight.
No support is needed.
Thanks to:
Alsamen (https://www.thingiverse.com/Alsamen/about) for the Unicorn model
Coat (https://www.thingiverse.com/Coat/about) for fillopening with plug
| Fluffy_The_Unicorn_Bank_-_Front_Slot.stl | 2.6MB | |
| Fluffy_The_Unicorn_Bank_-_Rear_Slot.stl | 2.4MB | |
| Screw_Plug.stl | 159.9KB |
