A wall mount for tablets that's invisible when viewed from most angles, holding the tablet 11mm from the wall. Should fit almost any tablet and is easily removable. Designed to be used with a 180 degree USB-C charging adapter (shown with this adapter).
The wall plate has 4mm holes placed 70mm apart to be screwed into drywall anchors, or small adhesive poster strips can be used in the corners as shown in the photos. It is important that the screws do not protrude over the surface, as they would otherwise contact and scratch the tablet.
Make sure to clean the surfaces well before applying the adhesive strips. Apply the strips to the tablet plate and place the pull tabs for removal over the holes. Route the charging cable through the grooves, then slide the tablet mount down onto the wall plate.
To remove the tablet, just slide it upward and take it off the wall. To remove the strips, pull the tabs through the hole, using pliers if necessary, until the strip is completely released.
| Tablet_Mount.f3d | 409.9KB | |
| Tablet_Plate.stl | 345.2KB | |
| Wall_Plate.stl | 115.7KB |
