The idea is the Bottom piece is printed at 100% infill so it sinks and the webbing will hold it into the aquarium terrain.
The middle and top piece should be printed with less infill, Middle section at 33 and Top at 10 so that they float.
Inside each section are hooks to tie the pieces together with fishing line. The base will hold the other two at the bottom of the tank creating a tower effect.
Tips are greatly appreciated and will allow me to upload more models!
Bitcoin Tip Address ~ 1K7NyEuTwLHWkEUjb37pqyPCi2S85ohfhg
| Castle_Bottom_V2_by_Mehdals_Print_at_100_Infill.stl | 47.0MB | |
| Castle_Middle_by_Mehdals_Print_at_33_Infill.stl | 43.7MB | |
| Castle_Top_by_Mehdals_Print_at_15_Infill.stl | 7.2MB |
