Similar design to the old wooden pencil cases where the case pivots open and close and a sliding lid to lock it all in place. Nowadays this is more useful for pens. I imagine its multi-purpose too - I am thinking about putting my 3d bits and pieces in this.
All pieces = No Support Needed
Infill 10% but with "Wall Line Count = 4" recommended so the bolt hole is strong (Its the only advanced setting to change in cura)
Only need 1 x M5 bolt to lock it together (M5 x 30mm) with optional nut.
(I actually only used a M5x24 and because it screws in firmly and taps itself as you screw in, no nut needed)
| Flip_Pencil_Box-Base.stl | 86.6KB | |
| Flip_Pencil_Box-Flip_top.stl | 90.8KB | |
| Flip_Pencil_Box-Sliding_Lid.stl | 20.9KB |
