I designed this box to house my SpotMicro robot with the remote.
The sides are 6mm thick board.
The crews are M4 x 16 sunken bolts except for the hinging part of the clasps, those are M3.
The webbing is 25 mm wide.
The wire for the clasps is made out of 3mm wire (from a cheap old hubcap)
All the yellow strips are printed standing up without support.
The grey corners are printed on their point, with support.
The black clasp parts are printed on their side with support.
The yellow clasps and side handles are printed on their back without support
If you understand Dutch, you can find an instruction video on YouTube: https://youtu.be/XwXxPuvGRwU
| 30cmEdgeSpotCase.stl | 16.3KB | |
| Flight_case_corner.stl | 201.1KB | |
| Flight_case_Spotmicro.step | 673.8KB | |
| Handvatclip.stl | 32.0KB | |
| LiggerVoorHalf.stl | 12.8KB | |
| SluitingClasp.stl | 35.8KB | |
| SluitingOnder.stl | 27.1KB | |
| SluitingVanger.stl | 43.2KB | |
| SluitrandBovenVoorL.stl | 3.5KB | |
| SluitrandBovenZijkantR.stl | 3.5KB | |
| SluitrandOnderVoorL.stl | 13.7KB | |
| SluitrandOnderZijkantR.stl | 18.1KB | |
| StaanderBoven.stl | 6.9KB | |
| StaanderOnder.stl | 10.9KB |
