Using an inexpensive flexible cooling hose i had laying around, i built a worklight for on my drill press.
Parts i used:
-search ebay for 'Flexible 1/2" Water Oil Coolant Pipe Hose'
-search ebay for '2 Pin Snap-in On/Off Position Snap Boat Rocker Switch'
-LED light: http://tinyurl.com/6ledlight
I spray painted the inside white and brushed on some ABS juice to strengthen it a bit more.
Two versions of the switch box are available; screw tabs on top en bottom (type A) and screw tabs on left and right side (type B)
| switch_block_type_A.123dx | 356.9KB | |
| switch_block_type_A.stl | 2.5MB | |
| switch_block_type_B.123dx | 324.8KB | |
| switch_block_type_B.stl | 2.4MB | |
| work_led_light_fitting.123dx | 117.0KB | |
| work_led_light_fitting.stl | 14.4MB |
