Not a very glamorous print, but highly functional. We walk up to 3 dogs at a time and having to carry their waste bags until we got to the next waste station was a little cumbersome. So I created a holder that can fit into the slot at the bottom of a Flexi Leash. After picking up the waste, you just tie the bag opening into a knot and place it in the center slot of the hook of the holder. We have placed up to 4 bags on the hook at a time with out any issues (we have two big dogs and one little one).
Edited 18 Jan 2022
I have added an update to my original Flexi leash dog bag holder. In my original design, it was possible for the bags to fall off depending on how the leash was held. So, I added a retainer clip to keep the bags from falling off. Both versions are in this post. The new one is labeled Flexi Leash Bag Holder Ver 2.stl
This is meant to print with supports, be careful when you remove the supports in the retainer clip that you don’t damage tabs.
For the hinge pin, I use a 3d finishing nail that I cut the head off and then cut it to 29/32“.
| Flexi_Leash_Bag_Holder_Ver_2.stl | 4.5MB | |
| Flexi_Leash_Bag_Retainer_Ver_2.stl | 1.0MB | |
| Flexi_Leash_Used_Bag_Holder.stl | 4.4MB |
