Flaura2 3D Printer Model
The file 'Flaura2 3D Printer Model' is (stl,pdf) file type, size is 1.4MB.
The file 'Flaura2 3D Printer Model' is (stl,pdf) file type, size is 1.4MB.
i printed this with 30%infill and 1.5 layer height , but its a longggg time to print
i use simplify3d for slicer and no need use supports on this design
if you have a small printer 220 by 220 mm, make sure you place your print in the middle of the printer in your slicer
its for plantpot Ø 190mm
and its made for treaded inserts from M4 8.1mm long and screws 4mm 10mm length
for the pump and the battery use 15mm lenght
try to put the inserts so straight possible in.
i added also the mount for the pump an the battery
if anyone has problems detecting the water level. This is because pure water is not a good conductor of electricity. What you can do is solder a very thin silver wire to each of the 6 wires. because silver is a better conductor
To attach the circuit board, you must round the corners of the board so that it fits perfectly
| BOTTOM.stl | 1.1MB | |
| BOTTOM_LAYOUT1.pdf | 134.9KB | |
| BOTTOM_LAYOUT2.pdf | 95.1KB | |
| INSIDEPOT.stl | 885.3KB | |
| mount_waterpump_and_pump.stl | 82.3KB | |
| OUTSIDE_POT.stl | 1.4MB | |
| POTLAYOUT.pdf | 112.7KB | |
| WATERLEVELSENSOR.stl | 345.4KB |
