Flashlight_clamp_clip Longer Shaft For Existing Attachment Port On Hhat 3D Printer Model
The file 'Flashlight_clamp_clip Longer Shaft For Existing Attachment Port On Hhat 3D Printer Model' is (stl) file type, size is 30.1KB.
The file 'Flashlight_clamp_clip Longer Shaft For Existing Attachment Port On Hhat 3D Printer Model' is (stl) file type, size is 30.1KB.
cour hard hats have a place on side for attachments. i just added a few mm so this holder would slide down and snap into that slot without the hardware the origional clamp required for hats without the slot. the origional is a great design, fit my light perfect after i adjusted it with the apps tagged in origional.
i used petg
inital 230c
220c after
no fans
70c bed temp
inclosed k1max
300mms
1.4mm layer
.5mm retraction(direct drive)
| 6583360.stl | 229.0KB |
